The software will automatically recognize which type of steering control (Dual
Joystick or Steering Wheel with Forward/Neutral/Reverse Joystick) is installed
and if there is one or two boxes connected. On machines with two boxes; the
Plus One will only operate if both boxes are of the same type.
Plus One will not allow the Engine Enable to come on until the Optimization
procedure has been done. Also for Codes 21 and/or 24
To optimize the Dual Joystick Steering Control Box:
1. Turn the machine off. Open the dash board panel and locate the
Optimize/Calibrate connector and plug it into the Optimize receptacle.
2. Place all joysticks in the center position and move the Run/Stop switch(s)
into the Stop position.
3. Turn the power key to the on position (power to the Plus One controller).
Outputs are disabled. The status light will blink a slow continuous blink to
indicate Optimize Mode.
4. Wait 5 seconds for the Plus One to capture the joysticks in center
position.
5. Push joysticks full forward for 5 seconds.
6. Push joysticks full reverse for 5 seconds.
7. If a second control box is present optimize it in the same manner.
8. The status light will stop blinking. Unplug the Optimize/Calibrate
connector from the Optimize receptacle and turn off the power key.
To Optimize the Steering Wheel with Forward/Neutral/Reverse
Joystick Control Box:
1. Turn the machine off. Open the dash board panel and locate the
Optimize/Calibrate connector and plug it into the Optimize receptacle.
2. Place all steering wheels and joysticks in the center position and move
the Run/Stop switch(s) into the Stop position.
NOTE
Be sure that the steering wheels are centered
3. Turn the power key to the on position (power to the Plus One controller).
Outputs are disabled. The status light will blink slowly with no pauses to
indicate Optimize Mode.
4. Wait 5 seconds for the Plus One to capture the steering wheel center
position.
5. Turn the steering wheel full right and push the FNR joystick full forward
for 5 seconds.
6. Turn the steering wheel full left and the FNR joystick full reverse for 5
seconds.
7. If a second control box is present optimize it in the same manner.
8. The status light will stop blinking. Unplug the Optimize/Calibrate
connector from the Optimize receptacle and turn off the power key.
0 Comments